Category index
Guards & Safety
3 documented faults under Guards & Safety. Each entry sets out the symptom as owners report it, the most likely cause, the checks that confirm or rule it out, and whether the repair is worth doing — compiled and cross-checked from manufacturer documentation and owner reports, with sources listed on every page.
Documented faults
- Record Power PT260
The PT260 won't start at all — the motor doesn't run when the switch is pressed, in either planing or thicknessing mode
One of the PT260's three safety microswitches isn't being closed by the table lock, the dust extraction hood, or the swing-over outlet — the interlock working as designed, not a fault
Guards & Safety 2026-09-15 - Makita UC4041A
The saw chain keeps moving even after the chain brake lever has been engaged
Worn brake band inside the clutch drum, which no longer grips hard enough to stop the chain when the brake is applied
Guards & Safety 2026-09-07 - Makita 5704R
Circular saw's lower blade guard returns slowly after a cut, hangs partway, or has to be flicked shut by hand
Resin and compacted sawdust in the guard's pivot ring binding its rotation — occasionally a stretched or detached return spring
Guards & Safety 2026-06-11
Other categories
Batteries & ChargingBlades & AlignmentChucks & FittingsElectronics & FirmwareMechanical & MotionMotor & DrivePumps & Pressure All categories →